Last Activity:06-11-2014 4:12 AM
1 Likes on 1 Posts
Posted in thread: JG AK47 Not Firing on 06-06-2014 at 05:38 AM
Did you tested it first? How was it? How about the batteries, are you sure they are still good?
Posted in thread: Legacy's Teching on 01-28-2014 at 02:30 AM
See if the wall of the GB which the tappet plate runs to have no obstruction that may create a
gap between the nozzle and the hop chamber.Check also for some bent on the tappet plate that
may create s...
Posted in thread: Question about M15A4 Buffer Tube on 10-31-2012 at 01:27 PM
other than that, the screw holds nd keep the spring guide in place as well as for the gbox in
the lower receiver.
Posted in thread: CYMA AK 104 sights on 10-31-2012 at 12:58 PM
check if the bump of the hop up is at the top center by lookng inside the inner barrel. if it
has offset, you have to center it. the flight of the bb depends on it
Posted in thread: Hallo on 10-21-2012 at 03:35 AM
W...W.....Wiseman. Dude, you haven't posted for like a year. Welcome back man, you were
missed.Also, new guy welcome to the forum.Yeah! It's all about work man. Having a hard time
making time for this...
Posted in thread: Mark From Thailand on 10-21-2012 at 03:32 AM
That's good. Airsoft promotes camaraderie. Welcome to AS man!
Posted in thread: Hallo on 10-21-2012 at 03:27 AM
Welcome to AS! Hope you'll like it here.
Posted in thread: Accuracy build on 10-21-2012 at 03:24 AM
Not necessarily new ones. But an air seal nozzle is necessary for good seal. To have a good
compression, you have to prevent leaks from the cylinder to cylinder head by applying sealant
or teflon tape...
Posted in thread: Pistons on 10-21-2012 at 03:11 AM
Yes it is is 450fps and also how do i know that i did i a good shim job because when i spin the
gears nothing rubs and when i close the gearbox and flick the gears the gears spin really well
and i can...
Posted in thread: m130 spring installation on 10-21-2012 at 02:32 AM
If the spring guide has a hole, what Rifle n Ready said will really help you inserting the
guide and hard spring into the GB. But if it doesn't have, try using precision screw driver to
hold the guide...