chumbro

G36 ftw

ok look on my picture albums titled g36 and there it is

not currently camera busted :( i will get it to you as soon as possible

just look around at airsoft retailers... nearly everyone carries such parts.

Chat as in chat room?
I'll PM you the link.

Just make sure you get a high torque motor, SP120 spring(NOT M120), reshim(at the least), test out a couple buckings(systema, prometheus, firefly, madbull, ect...), and get a quality tightbore(prometheus, edgi, PDI, systema).

stay away from JBU, madbull, matrix and other low end brands when searching for a tightbore. Remember, quality of the bore is more important than how tight it is. I've run stock TM barrels and gotten as good of accuracy or better than some low end tight bores.

first off, you will need to get a completely new front end. You need a G36E kit so you can run a 509mm barrel in there. Next, you will need to get a full cylinder, and a good bucking. its good to buy a few buckings and test them all to find which will perform best, and keep in mind that they will need some time to break in. So it might be a good idea to get a few buckings now and break them in and test them, and then do the rest of your upgrades and re-test them. Internally, it really depends on what energy output your looking for. I recommend starting at 430fps max. A guarder SP120 spring should do the trick. a set of Guarder standard ratio gears, and a high torque motor should be just fine for that setup. You may even be able to get away with stock gears if you get it re-shimmed and properly lubricated.

Mine is a tsd tactical gen 2 it shoots about 380 with my tightbore barrel

Great! What brand is it? Mine is a JG. Any upgrades? I have mine shooting at 18-19 BPS at 300 fps

welcome to the cave

I have a tsd tactical g36c