can G&G AK receivers accept real steel parts?

Discussion in 'General Airsoft Discussion' started by AznMunkay, Oct 11, 2012.

  1. AznMunkay

    AznMunkay New Member

    350
    0
    Providence
    I want a new AK receiver because my AKS Under folding stock receiver can't get any other stock. Will a Tapco stock fit?
     
  2. Scarred

    Scarred New Member

    1,329
    2
    I don't think so. Even if they do they are probably very expensive.
     

  3. richman992

    richman992 New Member

    1,366
    0
    Rochester
    I have a spare underfolding stock with parts, as well as a lower receiver for an ak47 that is meant for an underfolding stock...
     
  4. AznMunkay

    AznMunkay New Member

    350
    0
    Providence
    no I want a new stock that would accept a retractable stock
     
  5. NSWIntelGuy

    NSWIntelGuy New Member

    1,173
    0
    Oak Harbor
    No, they won't. There's a tab on the real AK stocks that feeds into the actual receiver; on airsoft AKs there is no tab; there's two tabs on the back that attach to the stock itself. On the real AK there's only one rear tab, and it's on the top. It's kinda hard to explain, but what I'm saying is the gospel truth... I have two real AKs and an airsoft AK, and the stocks DO NOT interchange. Neither do the hand guards. I tried that, too. Just the voice of experience
     
  6. AznMunkay

    AznMunkay New Member

    350
    0
    Providence
    where can I buy a stock converter because most stores are out of stock...
     
  7. NSWIntelGuy

    NSWIntelGuy New Member

    1,173
    0
    Oak Harbor
    you wanting to put an M4 stock on it? If so, one of the airsoft stores should have one... if not, you might be able to saw down a Tapco or Mako one. The Mako one is expensive though, so I don't know if you want to do that.