Airsoft Forum banner
1 - 1 of 1 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
Hey everyone. Recently, I bought a KJW KP-05 and a few co2 mags for it. Since I’ve had them, I’ve noticed that after inserting a new co2 cylinder, I can only make it about 5 shots into a full mag before the slide stops blowing back far enough to pick up a new round. About two dry shots later, the slide can’t even blow back far enough to knock the hammer back. This happens with both of my co2 magazines. Can anyone help me figure out what’s up?
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.