Airsoft Forum banner
61 - 67 of 67 Posts

·
Registered
Joined
·
69 Posts
Discussion Starter · #61 ·
That sector is in a less than ideal position.

With AR latch in a notch on the bevel gear to prevent rotation. Sector notch should have the tappet at rest.
Like this:
View attachment 279957

Just pull out your sector and rotate it by 2-3 teeth position and put it back in so the tappet isn't flexed. Plus having it flexed like that makes it harder to snap the box back together.
Ok got it since I correct AoE I thought it had to be assembled back like this so I can rotate it to sit like that either way and aoe should be fine?
 

·
Administrator
Joined
·
12,070 Posts
AOE is only measured when the sector picks up the piston.
Automotive tire Rim Metal Spoke Engineering


At final assembly, the gear should not be contacting the piston...otherwise as mentioned...you are not going to be able to close the box very easily.
 

·
Registered
Joined
·
69 Posts
Discussion Starter · #63 ·
AOE is only measured when the sector picks up the piston.
View attachment 279960

At final assembly, the gear should not be contacting the piston...otherwise as mentioned...you are not going to be able to close the box very easily.
Ok got it I will try again later thank you guys for always proving me with great info I will get back on here later with results
 

·
Registered
Joined
·
69 Posts
Discussion Starter · #64 ·
AOE is only measured when the sector picks up the piston.
View attachment 279960

At final assembly, the gear should not be contacting the piston...otherwise as mentioned...you are not going to be able to close the box very easily.
ok messed with it and the gearbox closed got everything put back but unfortunately the magnet I cut out isn’t thick enough to sit flush on the gear it’s in there but the sensor can’t read it does anyone know the measurements for these type of magnets?
Automotive tire Motor vehicle Bicycle tire Tire Bicycle part
 

·
Registered
Joined
·
69 Posts
Discussion Starter · #65 ·
ok messed with it and the gearbox closed got everything put back but unfortunately the magnet I cut out isn’t thick enough to sit flush on the gear it’s in there but the sensor can’t read it does anyone know the measurements for these type of magnets?
View attachment 279971
Ok got it I will try again later thank you guys for always proving me with great info I will get back on here later with results
Ok got it I will try again later thank you guys for always proving me with great info I will get back on here later with results
ok I found one that should work
Font Terrestrial plant Screenshot Calendar Wood
 

·
Registered
Joined
·
69 Posts
Discussion Starter · #67 ·
61 - 67 of 67 Posts
Top