Coversion kit

Discussion in 'General Airsoft Discussion' started by Sharp_Shot, Sep 17, 2012.

  1. Sharp_Shot

    Sharp_Shot New Member

    9
    0
    If i buy a G36-c is there a conversion kit i could buy to make it a G36-k

    Thanks for reading
     
  2. deathmechanic

    deathmechanic Active Member

    4,038
    1
    Davis
    Depends on which G36 you are purchasing. JGs will work with any TM styled conversion kits. KWA I have no experience with trying to put body pieces on it, but a large part of me says I doubt they will fit. ARES uses a different type of body front end so you'd have to use their kits.

    CAs have their own line but the G&G kits will also work.

    I've dealt with a couple conversion kits and CA is hands down my fav.

    http://www.airsoftextreme.com/store...oduct_info&cPath=407_425_552&products_id=2492

    I brought mine from a E length to a C length and loved it.
     

  3. Sharp_Shot

    Sharp_Shot New Member

    9
    0
    Thanks
    But I'm not sure what make is it because i was going to get one off
    my freind for alot cheaper then you would by online.
    So i dont no the make.

    But thanks anyway
     
  4. deathmechanic

    deathmechanic Active Member

    4,038
    1
    Davis
    Well hopefully its a quality brand. Of you get something like a CYMA G36 no conversion kit will bolt on.
     
  5. Sharp_Shot

    Sharp_Shot New Member

    9
    0
    Alright i must ask him.

    And also does anybody know a cheap airsoft website that sells them parts in europe
    because postong and packing cost alot from china and america and takes forever to ship.
     
  6. Sharp_Shot

    Sharp_Shot New Member

    9
    0
    Does anypne know wheres the best place to buy one