Crane Stock Question

Discussion in 'Beginners Forum' started by RLA, Dec 10, 2012.

  1. RLA

    RLA New Member

    50
    0
    While using my friend's KWA SR-10, I dropped it on the ground and the plastic piece holding the butt-plate on broke off. We were able to secure it with some electrical tape and duct tape, but I offered to replace it for him.

    I can't just buy him a new butt-plate as it's the entire piece almost so right now I am looking at replacing the crane stock and was wondering if I needed to go KWA or if I could buy just any crane stock for an M4/M16 and use that for his SR-10.

    Evike right now has a couple of them but the only issue I have is if they'd fit. Thanks in advance.
     
    Last edited: Dec 10, 2012
  2. marine121496

    marine121496 Wahahaha~ Supporting Member

    7,506
    2
    Ann Arbor
    Any crane stock will work, used you can find them for around 5-12ish dollars.
     

  3. JakeBworth

    JakeBworth New Member

    2,779
    0
    Hoboville
    I'm pretty sure it's a standard buffer tube so most airsoft crane stocks should fit.
    But don't buy one new, you can usually find one in the classifieds for around $10.
     
  4. RLA

    RLA New Member

    50
    0
    Thank you guys. Much appreciated.

    I will look over there.