g36 hopup

Discussion in 'Gun Building, Modifications & Repairs' started by covertslayer, Sep 29, 2012.

  1. covertslayer

    covertslayer New Member

    352
    0
    Aurora
    Hey all, I was trying to install an SRC metal hop-up on my g36c and it doesn't seem to be working. The bucking doesn't move a lot when I turn the knob and when it does, it increases or decreases the bump randomly. The two things I think caused it are:

    1. I did scrape the bucking around a lot so maybe I destroyed it.
    2. I installed the hop-up assembly wrong.

    Any help is appreciated :)
     
  2. Maestro2

    Maestro2 Member

    434
    2
    Chesapeake
    I had the same problem with my G36, i found the piece that pushes the nub to the bucking was too short. I just put a small piece of a pencil eraser above the nub and it seemed to fix the problem
     

  3. deathmechanic

    deathmechanic Active Member

    4,055
    17
    Davis
    The SRC hopup only works in SRC replicas. It does not fit in TMs, CAs, JGs, etc. So if you are installing it into a non SRC replica then thats your problem.
     
  4. covertslayer

    covertslayer New Member

    352
    0
    Aurora
    Yeah, that's it then. The G36c is an Echo 1. Thanks.