1. CajunAirsoft

    CajunAirsoft New Member

    413
    0
    Hey guys I was trying to dissasemble my Jg g36, but all the videos are for normal not crane stock version. I got it down to where you seperate the lower from upper ,and it just won't budge. Am I doing something wrong. I moved the hop up out of the way removed the screws and pin in the back and removed the motor screws.
     

    Attached Files:

  2. Thestig

    Thestig Some say... Supporting Member

    1,265
    1
    Colorado Springs and Southern California
    Did you put the gun in semi?
     

  3. CajunAirsoft

    CajunAirsoft New Member

    413
    0
    Yeah it is it just moves slightly when I push really hard and on most vids it slides right out.
     
  4. Thestig

    Thestig Some say... Supporting Member

    1,265
    1
    Colorado Springs and Southern California
    This is a stupid question, but did you remove the screw from the back, behind the gearbox?
     
  5. CajunAirsoft

    CajunAirsoft New Member

    413
    0
    I don't see a screw that your talking about sooo.... All u talking about this becauw there is no screw in it .
     

    Attached Files:

  6. CajunAirsoft

    CajunAirsoft New Member

    413
    0
    Okay I figured that out but how the heck do I get the fuse through here.
     

    Attached Files:

  7. CajunAirsoft

    CajunAirsoft New Member

    413
    0
    Okay major problem. My spring guide has no hole in it........ To compress the spring and close the gb.
     
  8. CajunAirsoft

    CajunAirsoft New Member

    413
    0
    Okay never mind the gearbox I'm not opening it today, but now how do you arrange these wires??my little thingy that holds then in pops out.
     

    Attached Files:

  9. CajunAirsoft

    CajunAirsoft New Member

    413
    0
    So there is almost no videos on this anyone know how to arrange these wires get it back in.