Glock G23 valve knocker problem

Discussion in 'Gas Powered Guns' started by men-ta-lyst, Aug 8, 2017.

  1. men-ta-lyst

    men-ta-lyst New Member

    2
    0
    Hi!

    I come here because I identified a problem with my Glock G23 but I don't know how to solve it!

    What I have seen:
    -I removed the slide and the magazine, I put the hammer in the "armed" position by hand and I activated the trigger. The hammer moved well and the valve knocker gone into the magazine hole perfectly. :)
    -I removed the slide and load the magazine with some gas. As before, I put the hammer in the "armed" position by hand and I activated the trigger. The hammer moved again well and all the gas was blown out which is a good thing. :)
    - But when I put back the slide and I try this, nothing happened ! :mad:
    I removed the magazine to understand what happened. In fact, when I activate the trigger, the "sound" of the hammer release is lower than without slide and the valve knocker does not go into the magazine hole as it should.

    I hope that my description is enough precise for you to help me.
    Thank you in advance for your help! :D