High torgue motor in stock jg m4

Discussion in 'Gun Building, Modifications & Repairs' started by tacmonkey141, Aug 14, 2012.

  1. tacmonkey141

    tacmonkey141 New Member

    123
    0
    merced county
    Will I be able to use a high torgue motor in a stock jg m4 without problems? with a 9.6v battery?
     
  2. EDI1st

    EDI1st New Member

    2,062
    3
    Fountain Valley
    Um, most JG comes with the M42 which already has enough torque to pull an MS210....So check the motor first...
     

  3. tacmonkey141

    tacmonkey141 New Member

    123
    0
    merced county
    I want better trigger response and a little higher rate of fire
     
  4. Batman

    Batman New Member

    1,554
    0
    Wichita
    Deans. .
     
  5. EDI1st

    EDI1st New Member

    2,062
    3
    Fountain Valley
    And high speed gear set and MOSFET
     
  6. tacmonkey141

    tacmonkey141 New Member

    123
    0
    merced county
    High torgue motor? Is that a yes or no?
     
  7. EDI1st

    EDI1st New Member

    2,062
    3
    Fountain Valley
    Yes, high torque motor + high speed gear set = instant trigger response.
    10.44 DSG + JG M42 = this
    [ame]http://www.youtube.com/watch?v=vFp-NesnUQE[/ame]
     
  8. tacmonkey141

    tacmonkey141 New Member

    123
    0
    merced county
  9. EDI1st

    EDI1st New Member

    2,062
    3
    Fountain Valley
    SHS, VS, Lonex, Riot SC
     
  10. TboneH

    TboneH New Member

    23
    0
    Riverside
    I've got an SHS hi torque in my stock (aside from a tightbore) Echo 1 AK, and since Echo and JG internals are pretty much the same, I'd say it's a safe bet. In addition to pretty much instant trigger response, I've also got a pretty high rate of fire. It can almost keep up with my KWA on a 9.6. Replace your connectors too; tamiya connectors are garbage. Deans are good but I run XT60's on all of my guns. They're a little bit bigger, but are supposed to be better and are easier to solder.