How do i remove a flash hider from a G&G Commando Raider

Discussion in 'Gun Building, Modifications & Repairs' started by legendairsoft, Dec 24, 2012.

  1. legendairsoft

    legendairsoft New Member

    4
    0
    HEMET
    Hi, I have a full meteal g&g Raider. I need to install a Noveske flash hider. I dont see a hex screw/key. Its just silver where the hex key is supposed to be, please help, Thanks.
     
  2. stroop66

    stroop66 New Member

    588
    0
    not going to happen, they are way to over glued!
     

  3. Joshpeck

    Joshpeck New Member

    812
    0
    Eau Claire
    I have heard sticking the barrel in boiling water removes that pesky glue underneath however When I tried it ha no results for me. After that I decided cut off the plastic flash hider. I was VERY careful about doing so. On my leatherman I used the file to file a straight line along the seem, and I did the same on the opposite side to it. After done filling I basically just broke it in half.
    I was successful with no damage towards the barrel but I don't know if I would recommend what I did.
     
  4. Joshpeck

    Joshpeck New Member

    812
    0
    Eau Claire
    But I HATE the external barrels on those buns so i would change it out for a new one.