M4 feeding issue

Discussion in 'Electric Guns' started by C1TY_17, Nov 27, 2012.

  1. C1TY_17

    C1TY_17 New Member

    30
    0
    Hello! I've searched pretty far and wide on people who have had this problem but so far I haven't had much luck. The base gun is a combat machine but its been internally upgrade inside and out. I had recently purchased a MOSFET and I wired it the front through a mod in the delta ring. However since I did that I have been having a lot of feeding problems. I have to hold every mag I have upwards so it can feed. I have a lot of different brand mags for testing, but none have work. is there a special part i can get to ensure feeding? I run an 11.1 lipo. I have thought about a sector chip but I don't see how that would help. The wires are perfect in the magwell.
     
  2. Archer627

    Archer627 New Member

    6,174
    5
    Figgington
    Put some tape on the mag or put a piece of velcro in the back of the magwell. That should push your mag up into the chamber's feeding tube and help out.
     

  3. C1TY_17

    C1TY_17 New Member

    30
    0
    Thanks! I've never heard of putting Velcro on. That's a great idea.