Need help with hopup bucking and mosfet problems

Discussion in 'Gun Building, Modifications & Repairs' started by jtkyber, Nov 13, 2016.

  1. jtkyber

    jtkyber New Member

    23
    0
    Marietta
    So I came across some issues today when installing a new barrel and hopup bucking. When I slid the Hopup unit over the bucking, it was an incredibly tight fit (yes I lubed it). The only way I could get it on was by stretching the bucking a little. I had to cut some of it with a razor blade so I could attach the c clip. The nub shows through the bucking fine so does that mean it will perform fine? Also, because the hopup unit is so tightly attached to the bucking/barrel, I can't get it off. I even tried silicon oil and a wretch. Is my only option to cut the whole hopup unit off and buy a new one?

    My second problem was with the Burst Wizard King Kong Super 2 MOSFET. I cannot configure anything. I pull the trigger on semi as soon as I plug it to the battery like I'm supposed to but it just fires normally. The mosfet should blink however many times I pull the trigger but it just fires instead. It worked the very 1st time I plugged it in but now it doesn't. What am I doing wrong?

    Here's a list of my gun and the parts if that helps:
    http://www.airsoftgi.com/product_info.php?products_id=20885
    http://www.evike.com/products/24373/
    http://www.evike.com/products/36022/
    http://www.evike.com/products/49578/
     
  2. Lefse

    Lefse Well-Known Member Supporting Member

    6,226
    1,837
    Regarding the hop-up chamber, maybe try heating it? It should soften everything up and possibly cause the hop-up chamber to expand a little so it'll be easier to slide it off.

    I have no experience with the burst Wizard, so can't really help you there.
     

  3. Jeranhound

    Jeranhound Active Member

    851
    219
    Seattleish
    In the future, try not to lube the bucking. The rubber will just absorb any oil you use and swell larger, making things worse and throwing off your aim.
     
  4. jtkyber

    jtkyber New Member

    23
    0
    Marietta
    Alright, thanks! I'll definitely do that when I replace the hopup chamber with a metal one.
     
  5. jtkyber

    jtkyber New Member

    23
    0
    Marietta
    Thanks for the tip! I did not know that. That's probably why I can't get the hopup chamber off. So far, the gun is shooting very accurately, even with the stretched bucking. Hopefully it won't get worse like you say.