Need help with rail system

Discussion in 'Gun Building, Modifications & Repairs' started by brettcp97, Jul 23, 2012.

  1. brettcp97

    brettcp97 New Member

    124
    0
    birmingham
    Ok I want to put some rails on my boring m4. My problem is that I don't want to buy a new outer barrel. So i was wondering if this rail system is two piece, http://www.evike.com/product_info.php?cPath=25_106_286&products_id=29446, because i cannot remove the front sight from my outer barrel and if it is not two piece then I'm not really sure how to install it.

    The is basically what the front end looks like. http://www.evike.com/product_info.php?cPath=25_88&products_id=26174

    Thanks for any help.
     
  2. Fickert

    Fickert New Member

    77
    0
    Covington
    Its a two piece you will be fine. The screw on the end closest to your receiver holds on the bottom to the front part. Slide on the front over your barrel, drop it down over your front sight, put the bottom on and tighten the delta ring.
     

  3. brettcp97

    brettcp97 New Member

    124
    0
    birmingham
    Thanks a lot for your help!