PRS stock users!!!help!

Discussion in 'Gun Building, Modifications & Repairs' started by DeadOnAirsoft, Aug 2, 2012.

  1. DeadOnAirsoft

    DeadOnAirsoft New Member

    38
    0
    Canton
    Hey so I installed a PTS PRS stock on an m4 lower receiver as directed and its got tons of wobble. I can twist it a clockwise and counter clockwise like 30° each way. Anyone ever have this problem? Solution?
     
    Last edited: Aug 2, 2012
  2. Mystery43_4

    Mystery43_4 New Member

    1,307
    2
    Santa Barbara
    Do you have the plastic spacer?

    If you don't then you'll have this issue. It goes over the small rectangle just below the buffer tube where the stock meets the receiver.

    In this pic, it's the small plastic spacer between the two screws at the bottom of the pic.
     

    Attached Files:


  3. DeadOnAirsoft

    DeadOnAirsoft New Member

    38
    0
    Canton
    Theres the issue. Sucker didn't come with one. Ever have this issue? Any home remedies?
     
  4. Mystery43_4

    Mystery43_4 New Member

    1,307
    2
    Santa Barbara
    Well that sucks. Always a PITA when products come missing a few parts.

    Well depending on where you got it from, you could get ahold of them and ask if they'll send you one.

    That or you could make your own. I would just make my own if I were you.