Should i replace my sears?

Discussion in 'Sniper Rifles' started by dylan484, Aug 9, 2012.

  1. dylan484

    dylan484 New Member

    441
    0
    Tifton
    My jg bar 10 is having bolt issues. It's fine pulling it back but pushing it forward is kinda hard. I'm pretty sure it was this hard out of the box.

    Any suggestions?

    I have also upgraded the spring and piston.
     
  2. svd_sniper

    svd_sniper New Member

    79
    0
    Ho Chi Minh
    you need to dissamble your gun to find out true problem man
     

  3. dylan484

    dylan484 New Member

    441
    0
    Tifton
    I've taken it apart ive just never really looked at my sears before this so I'm not sure how to tell if worn. I know the cylinder isn't scraping on the outside it's on the inside of it
     
  4. ncore

    ncore New Member

    1,064
    0
    Pittsburgh
    take a few pics, it will be easier for us to help you
     
  5. dylan484

    dylan484 New Member

    441
    0
    Tifton
    Here's some pics

    In the receiver

    image-2613370903.jpg



    image-1553025697.jpg

    Removed


    image-1696997176.jpg



    image-2955567679.jpg

    The sear is kindaaaa mushrooming over the edge.
     
  6. EDI1st

    EDI1st New Member

    2,062
    3
    Fountain Valley
    Um, why not try to find some scratch marks or area with heavier worn marks on the cylinder....?
     
  7. EDI1st

    EDI1st New Member

    2,062
    3
    Fountain Valley
    Or just don't buy from Airsoft Atlanta because they are over priced....
     
  8. dylan484

    dylan484 New Member

    441
    0
    Tifton
    They have decent bb prices