socom gear m700 bolt problem HELP

Discussion in 'Gun Building, Modifications & Repairs' started by sniper291996, Sep 11, 2012.

  1. sniper291996

    sniper291996 New Member

    10
    0
    Alright. I just put in all the AGI PE parts the piston, spring, sear set, barrel and hop up rubber in. put it all back together. The first mag went through just fine. But then it wouldn’t shoot. The trigger went back just fine and I could feel it slide off the trigger sear but it just didn’t let the piston go. So then I messed around with it some and figured out that it would shoot if I pulled the trigger and pushed the back of the bolt really hard and it would fire.
    I am really puzzled on why this is happening so any help would be greatly appreciated.
     
  2. sniper291996

    sniper291996 New Member

    10
    0
    soloved my problem. I just replaced the trigger sear spring with the stock one and switched out the spring stop with the stock one also.I'm just posting this so if any one else has the same problem they can hopfully fix it.