Well, a year ago I bought one of my first two airsoft guns- a JG G3. Specifically their T3 K3- long barrel, full stock. In otherwords, a G3A3. This: https://www.airsoftmegastore.com/ProductDetails.asp?ProductCode=JG-100-T3K3 I'd like to turn it into a DMR, so... I could use some suggestions. I'm really not looking to optimize it for skirmishability, though (see note at bottom of post). So, I guess... a bipod, a scope, and maybe a cheek pad would suffice since it has a tightbore barrel, stock, and I really don't want to dig into the gun's internals... at all. :/ Bad experiences... First question: There's a Classic Army bipod for their G3 on Airsoft GI (CA FS3 Bipod by: Classic Army - Airsoft GI - Welcome to the ultimate). Would it fit on JG's G3 without trouble? If not, what will? Second question: In looking for scope rails for G3s, I find that people often have problems fitting them to a G3, but not an MP5, so... I'd like an educated person to recommend me a scope rail for it. :s Perhaps a scope too, but I know what I'm lookin' for, there. Third question: Looking just on Airsoft GI, I can't find a sniper's cheek pad. Just ammo holders. Help? x_x I'm short on time nowadays. Sorry if any of these questions are dumb. ^^; Help is appreciated, guys. Note - This is my way of squirming out of digging into the gearbox and crap to replace the spring and stuff, which would certainly result in me screwing the gun up and having it sent back for repairs (again). -.-; I know if I wanted to make it a quality gun, I'd probably have to gut the damn thing, since it's a JG, and that's out of the question... for now.