Upgrading Internals on my AEG

Discussion in 'Introductions' started by DarteR, Jul 27, 2017.

  1. DarteR

    DarteR New Member

    8
    0
    Rancho Santa Margarita
    Upgrades I've been looking to get: [​IMG]

    I'm looking to upgrade my G&G CM16 Combat Machine Raider internals. Is there anything I should add, remove, or any suggestions. Also if I got these upgrades on my cm16, then in future bought a new gun with a metal body, could I take out the parts and put them into the new gun? Thanks any recommendations and suggestions will help!:):)
     
    Last edited: Jul 27, 2017
  2. AnotherM4Normie

    AnotherM4Normie Member

    378
    3
    Auckland
    Hmm, let me see:

    #1 Never buy parts from evike. Use Brill Armory or Clandestine Airsoft instead. Better parts, prices and customer service.

    #2 You will want a bigger battery for a setup like this.

    #3 I don't trust matrix parts.

    #4 ASCU MOSFETS are rife with problems. Get a GATE TITAN.

    #5 Angel Custom barrels are terrible. Get a ZCI instead.

    #6 I don't trust APS parts either.

    #7 You probably won't need a new cylinder.

    #8 For such a high-stress build, the G&G gearbox will most likely break in next to no time (if you make it to the 75k cycles mark I'll print this post and eat it).

    #9 You are going to want to get some proper grease.


    Really, I'd recommend you build an equivalent parts list on Brill armoury and make another post in the correct section of this forum asking for opinions.
     

  3. DarteR

    DarteR New Member

    8
    0
    Rancho Santa Margarita
    Ok, which section of the forum should I post a different build?
     
  4. AnotherM4Normie

    AnotherM4Normie Member

    378
    3
    Auckland
    "Gun Building, Modifications & Repairs"