UTG rail space

Discussion in 'Gun Building, Modifications & Repairs' started by chineseairsofterss, Dec 18, 2012.

  1. chineseairsofterss

    chineseairsofterss New Member

    755
    0
    I installed this new UTG rail onto my G&P, but there seems to be a little space between the gun and the actual rail. This made then gun look a little off, but no matter how hard i twist it, the rail just wont go any further. Any ideas?

    .jpg
     
  2. Archer627

    Archer627 New Member

    6,174
    5
    Figgington
    The threading is different on the G&P upper. You will have to Rethread it to take Airsoft-spec RIS platforms.
     
    Last edited: Dec 18, 2012

  3. chineseairsofterss

    chineseairsofterss New Member

    755
    0
    How would I rethread the upper receiver?
     
  4. Archer627

    Archer627 New Member

    6,174
    5
    Figgington
    Using a die with the correct thread pitch, diameter, and thread count in a certain distance. Honestly, I don't know if you have the skills to attempt if you had to ask how.
     
  5. chineseairsofterss

    chineseairsofterss New Member

    755
    0
    Yeah I dont, is that my only option?
     
  6. Archer627

    Archer627 New Member

    6,174
    5
    Figgington
    Yeah, basically. Lol.