Vfc m16 Sling Help.

Discussion in 'General Accessory Discussion' started by kean101, Sep 10, 2012.

  1. kean101

    kean101 New Member

    10
    0
    I just ordered the vfc m16a3 and i have to install the front sling point myself but it basically came with a pin and the sling loop but when i try to fit it in the hole's it wont go in do i need to force it? or is their a certain angle i need to put it in it has a notch going all the way down the pin so im thinking that might have something to do with it. Any suggestions?
     
  2. Username94

    Username94 New Member

    2,718
    0
    New York City
    Yo should be able to push it in to a certain degree. Then you hammer it in.
     

  3. kean101

    kean101 New Member

    10
    0
    Thanks it took a little bit of elbow grease but i got it in finally hopefully i left enough out the pine to get it out with pliers if i need to probably not though.
     
  4. Username94

    Username94 New Member

    2,718
    0
    New York City
    You don't have to leave some of it sticking out. When you want to remove it you would push it through with a nail and a hammer.